The evolution in O2-sensor conditioners. With a new design, the fueltech NanoPro is able to condition and read 5 different models of wide band lambda O2 sensors! The NanoPro comes with the following features:
- “Switch Panel” function, touchscreen buttons or switches via CAN bus to Fueltech ECU’s.
- 3 configurable O2 sensor heating modes: Normal, Fast and Current Limited, as well with auto startup, activated by engine RPM or temperature
- Extended wideband reading scale with advanced new hardware that allows fast and precise readings.
- Advanced heater diagnostics in the PowerFT ECU datalogger.
- “Second display gauge” function that allows display valuable information like Oil Pressure, Fuel Pressure, Boost, RPM, Engine Temperature and much more coming from the FTCAN 2.0, with the possibility of configuring up to 5 custom screens.
- Waterproof (IP67 certified*) —- *with product harness connected
- 2” Color LCD touchscreen display.
- Compatible with 5 different models of O2 sensors: Bosch 4.2 / Bosch4.9 / Bosch 5.2 / NTK ZFAS-U2 (laboratory) and NTK ZFAS-A2 (PN: UAR0004)
- 0-5V analog output for connection with any data acquisition or programmable injection system.
- Different fuels AFR or lambda display unit options **
- Lambda (0.21 – 9.99)
- AFR Methanol (1.35 – 64.6)
- AFR Gasoline (3.09 – 146.6)
- AFR Ethanol (1.89 – 89.9)
- ** The reading range can reach values slightly lower or higher than 0.21 λ, depending on the manufacturing characteristics of the sensor.
- CAN communication with Power FT ECU’s:
- “Second display gauge” function that allows display valuable information like Oil Pressure, Fuel Pressure, Boost, RPM, Engine Temperature and much more coming from the FTCAN 2.0, with the possibility of configuring up to 5 custom screens
- “Switch Panel” function, touchscreen buttons or switches via CAN bus to the PowerFT ECU
- – Maximum power supply voltage: 20V
- Dimensions: 2.64″ x 1.83″ x 1.48″
- Module: 1.84 oz, product 3.99 oz.
The FuelTech NanoPRO has the same connector as the already established WB-O2 NANO, so if the vehicle already has a NANO installed, just disconnect it and install the new NanoPRO in the place of the current module.